TD35 Tower

The TD35 Tower makes for an excellent vertical truss that allows the safe, quick lifting of regularly loaded horizontal ST Truss Rig and Roofs

to their service height. In terms of static, the TD35 Tower is designed for a high flexural- and pressure strain.

Especially due to the roofs this high flexural strain is required.

TD35 Tower Truss is a square 35cm heavy duty truss with one on side inte- grated horizontal bracing for safe and easy climbing.

Naturally this TD35 Truss has been made according DIN EN 1999- 1-1 & 1999 -1-1/A2 within Eurocode 9 and approved by TuV.

Facts

  • Steel base equipped with high quality cast wheels
  • Sleeve block made out of a ST corner block
  • Multifunctional Top Part for use with manual and motorized hoists
  • Up to 14 meters (46 ft.)

 

Top section & Sleeve Blocks

A new multifunctional top part for use of manual chain hoist as well as motori- zed hoist has been redesigned and built stronger.

Standard sized ST corner block with the usage of 2 bolted sleeve plates guarantees a perfect geometric rig. These blocks make it possible to fit the ST Truss to all four sides by using bolted receivers. The upper sleeve plate is equipped with an integrated hanging point.

Hinge set

A strong, safe and cost effective solution to erect the TD35 Tower. The hinge sets are 100mm long. Those half connectors with a hinge fork allow a very high vertical load.

4 Hinge sets (2 left and 2 right) are required per tower.

Base section & Outriggers

Steel Base on wheels available with short outriggers and long outriggers in combination with stabilizer bars.

Technische Daten

Max. Height
14 m. (46 ft)
Max. Loading
2000 kg (4400 lbs.)
Tower Truss
TD35
Sleeve Block
ST

EUROTRUSS
Products you can count on, people you can trust!